smps

Discussion in 'Power Supplies and UPS's' started by suresh, Feb 9, 2008.

  1. suresh

    suresh Geek Trainee

    Likes Received:
    0
    Trophy Points:
    0
    hi to all
    well i am facing the problem that my smps was dead
    the old system had at power supply so i see their is only two wires for the on off switch
    i had bought new smps but it is for pentium4 atx and my mother board too supports atx and at

    here i give details
    motherboard is intel 810 chipset
    celeron 744 mhz

    i want to know what should i connect to the switch which os on /off

    please help me

    awaiting best replies
     
  2. Big B

    Big B HWF Godfather

    Likes Received:
    145
    Trophy Points:
    63
    If it's ATX, you'll need to connect the single 20 or 24-pin ATX connector (2x10 or 2x12 block) to the motherboard. You won't need to run a new switch for ATX like you do with AT.
     

Share This Page