My Audio Ports in the back don't work!

Discussion in 'Sound Cards and Speakers' started by swordzero001, Feb 5, 2009.

  1. swordzero001

    swordzero001 Geek Trainee

    Likes Received:
    0
    Trophy Points:
    0
    Hi, the audio ports in the back don't work because they're disconnected and I don't know how to connect the there's a picture to se if you can help me.
    My PC: AMD Athlon 64 X2, Asus M2N-MX SE Plus
    (http://img353.imageshack.us/img353/4701/mainboardhz2.jpg)
    The audio cables disconnected are: R-Out y R-Ret (On the same), L-Out y L-Ret (On the same), MIC-IN, MIC-POWER y GND.
    Any help would be very much appreciated.
     
  2. RHochstenbach

    RHochstenbach Administrator

    Likes Received:
    26
    Trophy Points:
    48
    You should connect them to the green block at the lower left corner of the motherboard.

    [​IMG]

    Now connect your cables to these connectors:

    R-Out > Line Out_R
    L-Out > Line Out_L
    MIC-POWER > Mic2_R
    MIC-IN > MIC2_L
    To connect the other side of each plug, use the pin that is on the opposite of the other connector.
     
  3. swordzero001

    swordzero001 Geek Trainee

    Likes Received:
    0
    Trophy Points:
    0
    Thanks, but where do I put every Pin?
    I have these R-Out y R-Ret (On the same), L-Out y L-Ret (On the same), MIC-IN, MIC-POWER y GND, but you put MIC2-L, MIC2-R, etc.
     
  4. RHochstenbach

    RHochstenbach Administrator

    Likes Received:
    26
    Trophy Points:
    48
    I'm sorry, I was editing my post while you where replying :)

    Does every connector have 2 wires?
     
  5. swordzero001

    swordzero001 Geek Trainee

    Likes Received:
    0
    Trophy Points:
    0
    Thanks Man gonna do that as soon as I turn off my PC (in 10 minutes.)

    EDIT:Only R-Out y R-Ret (On the same), L-Out y L-Ret (On the same)
     
  6. swordzero001

    swordzero001 Geek Trainee

    Likes Received:
    0
    Trophy Points:
    0
    It didn't work, attached is a image explaining how I connected it (I may be wrong about the OUT/RET but I tried both ways)
     

    Attached Files:

  7. RHochstenbach

    RHochstenbach Administrator

    Likes Received:
    26
    Trophy Points:
    48
    The OUT and RET should be plugged in the other direction. But try to connect the R-RET with the NC between Line Out R and Line Out L.
     

Share This Page